Brake pad and brake disc running-in method and precautions
The new brake pads need to be worn with the brake discs at the beginning of use, so that the brake pads are better used. So what is the way to brake the brake pads and brake discs? What should you pay attention to when the brake pads and brake discs are worn together? The following small series will explain the brake pad and brake disc running-in method and precautions for everyone.
Brake pad and brake disc running-in method
1. After the brake pads are installed, find the place where the road conditions are good and the car starts to run in;
2. Accelerate the car to 100 km/h;
3. lightly brake the brakes with medium power to reduce the speed to about 10-20 km / h;
4. Release the brake for a few kilometers to cool the brake pads and the sheet slightly.
5. Repeat steps 2-4 above for at least 10 times.
Brake pad wear-in needs to pay attention to
1. In every 100 to 10-20km/h brake, it is not strictly required to require a very accurate speed every time. Acceleration to about 100km/h can start this braking cycle;
2. When you brake to 10-20km/h, there is no need to keep an eye on the speedometer. Just keep your eyes looking at the road and make sure that the road is safe. About every braking cycle, the brakes are almost 10-20km/ h is fine;
3. the new brake pad running-in method is to use the point brake to brake as much as possible, do not use the sudden brake before the wear-in;
4. The ten brake cycles are in progress, and the vehicle cannot be stopped until you want to make the brake pad material into the brake disc, causing the brake to vibrate;
5. After the running-in brake pads still need to pass through the brake disc for several hundred kilometers to achieve the best performance, be sure to drive carefully to prevent accidents.
The above is about the brake pad and brake disc running-in method and the main items. I hope everyone can understand the brake pads and brake disc running-in methods and main items, and it will help everyone.